Phoenix Gold Sx Series 1200W Mono-Block Amplifier

Phoenix Gold Sx Series 1200W Mono-Block Amplifier

Reproduce the full dynamic impact of each bass note, and deliver clear, articulate bass through your subwoofers with maximum power and efficiency. SX2 1200.1 monoblock subwoofer amplifier drives 1200 watts into 1 ohm.

• Class D Topology
• Power Rating:  600w x 1 Channel @ 4 ohm, 900w x 1 Channel @ 2 ohm, 1200w x 1 Channel @ 1 ohm
• Dimensions: 17.25” L x 8.25” W x 2” H - 439mm L x 210mm W x 51mm H

 

Premium Build Quality for Ultra Performance

• Legendary Phoenix Gold massive unregulated power supply built for dynamic headroom and to drive low 1ohm impedance loads
• Audio Precision Quality Control Verification

 

Chassis Features

• Master/Slave strappable for huge power and multi-amp setups
• RMD port allows you to add a remote monitoring display, giving you a visual of the voltage of your system
• Double tier power supplies with OTM Onboard Thermal Management
• Remote bass and phase controller with Bass Shift® (RBPC)
• Switchable balanced or unbalanced inputs
• Auto-turn on circuit (defeatable)
• Tri-light LED amplifier status indicators with short circuit, thermal and voltage protection
• Front mount controls and connections
• RCA pass-through outputs

 

Total Control of Your Music Output

Variable filters on each channel allow you to fine tune your musical output to the precision you demand. All crossovers feature aluminum shaft precision potentiometers for exact crossover frequency selection.

• Low Pass Crossover Range of 40Hz to 240Hz, you get quality lower bass
• Subsonic Crossover Range of 10Hz to 120Hz to eliminate unwanted ultra low frequencies, improving the efficiency of your subwoofer
• Bass Boost 0 to +6dB at 40Hz
• Variable phase output can be adjusted 0 to 180 degrees. This adjustment can help achieve better “up front” bass, by enhancing your sub bass and mid bass transition and resolve subwoofer cancellation problems in certain installations.  Resulting in tight, articulate bass that blends perfectly into the rest of your audio experience

 

Specifications

Frequency Response	± 6dB from 11Hz to 250Hz
Signal to Noise Ratio	86.3dB
Low Pass Crossover	12dB per Octave
Subsonic Filter	12dB per Octave
Low Pass Crossover Range	40Hz to 240Hz
Subsonic Crossover Range	10Hz to 120Hz
Bass Boost @ 40Hz	0 to +6dB
Low Level Input Range	300 millivolts to 8V unbalanced
Lowest Recommended Load	1 ohm
Typical Efficiency	85%
Damping Factor	Greater than 200
Variable Phase Adjustment	0 to 180 Degrees
RMS Power Output	600w x 1 @ 4 ohm 900w x 1 @ 2 ohm   1200w x 1 @ 1 ohm

 

Recommend Power Wire Fuse: 80A

Power/Ground Wire Size: 4GA

Write a review

Your Name:

Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: