Rockford Fosgate Prime R150X2 - 2 Channel Amplifier

Rockford Fosgate Prime R150X2 - 2 Channel Amplifier

Rockford Fosgate amplification at an unbelievable value. The R150X2 2-channel amplifier pumps out more than enough to power a set full-range or component speakers, or you can bridge it into a 4-ohm load to produce 150 watts for a single R1S410 10" or R1S412 12" woofer. Check out our RFTECH:Woofer WiringWizard to get the most out of your amplifier. 
 

• 12dB/octave Butterworth crossover
• On-board Punch EQ with +18dB boost @ 45Hz.
• RCA pass-thru outputs
• High Level Input (4-pin)
• Real time output and power supply thermal sensing
• Cast aluminum heatsink
• 4 Gauge power/ground connectors
• MOSFET power supply
• Over current protection
• Short circuit protection
• Muted turn on

Specification:

• Number of Channels: 2
• Rated Power(RMS Continuous Power): 50 Watts x 2 @ 4-Ohm
• Rated Power(RMS Continuous Power): 75 Watts x 2 @ 2-Ohm
• Rated Power(RMS Continuous Power): 150 Watts x 1 @ 4-Ohm Bridged
• Total Power(Sum of Rated Power): 150 Watts RMS
• Dynamic Power (PVC/PowerCube® Measurement): 61 Watts x 2 @ 4-Ohms 0° Res
• Dynamic Power (PVC/PowerCube® Measurement): 94 Watts x 2 @ 2-Ohms 0° Res
• Bridgeable     
• Frequency Response: 20Hz to 20kHz +/-1dB
• Efficiency (average): 66% @ 4-Ohm
• Total Harmonic Distortion (THD+Noise): 4-Ohm: <1.0% / 2-Ohm: <1.0%
• Crossover Controls: High-Pass/Low-Pass (HP/LP): 50-250Hz @ 12dB/octave Butterworth
• Tone Controls: Punch Bass: 0dB to +12dB @ 45Hz
• Input Sensitivity: 150 mV to 4 V
• Signal Input: Low Level: 1 RCA pair
• Signal Output:       Level: 1 RCA pair
• Power Input Connector: Screw terminal
• Power Wire Gauge: 4 AWG
• Speaker Output Connector: Screw terminal
• Speaker Wire Gauge: 8 AWG
• Heat Sink Type: Extruded Aluminium
• Cooling: Convection
• Visual Indicators: Power/Protect LED
• Circuit Topology Class: Class-A/B
• Operating Voltage: 9 - 16 VDC
• Recommended Fuse (not included): 20 A
• Max. Current Draw (13.8V Sinewave): 20 A
• Average Current Draw (13.8V Music): 10 A
• Suggested Alternator: 75 A
• Shipping Weight: 6.6 Lbs. (2.99 Kg.)
• Dimensions (HxWxL): 1.98 x 6.77 x 11.22 (in) / 5 x 17.2 x 28.5 (cm)

Write a review

Your Name:

Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: